DOD SR400D Dokumentacja Pobierz pdf (Strona 120)

112

OPERATING PROCEDURES

 9. Turn the pressure relief valve lever, located on the

left side of the pump, clockwise (up) to the non-

pressure position.

 10. Close the choke, located on the carburetor (under

the air filter) by lifting the lever. Open the choke as

the engine warms up. (Omit this step if the engine

is already warm).

 11. Remove the spark plug ground; pull the starter

rope firmly until engine starts. CAUTION:

HEARING PROTECTION REQUIRED. Throttle

lever (located under the air filter) square rod must

be pulled all the way out.

 12. Turn pressure relief valve down, (counter-

clockwise). Adjust the pressure- (0-450 psi) when

using hose/spray-gun at 200 psi normally. Open

both inline valves to pressurize.

 13. Conduct the spray operation by pulling the spray

gun trigger. The spray pattern can be adjusted

behind trigger lever.

TERMINATING PROCEDURES

 14. After ceasing spray operations, close both inline

valves first. Release pressure adjusting valve turn

clockwise up to release all pressure. Drain all

pressure out of spray hose. Push sparkplug

ground against sparkplug.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 243 244

Brak uwag

DOD SR400D Dokumentacja Strona 120